Welcome to your H&S and Regulations Exam. When you are ready, please press "start quiz".
1.
Heights of sockets and switches from finished floor level in a new domestic dwelling, should be?
2.
What is the distance, for how far away switches and sockets must be from gas pipework, according to the building regulations?
3.
Which specific location would not be included in the scope of BS7671?
4.
The ambient air temperature rating factor for 90ºC thermosetting cables operating in an ambient air temperature of 60ºC is?
5.
The image represents which type of earthing system?
6.
When cables are placed directly in the ground they should be buried at a depth?
7.
The ambient air temperature rating factor for 90ºC thermosetting cables operating in an ambient air temperature of 60ºC is?
8.
What should be made part of a PEI design to help combine information or data from or to the DNO, Electricity supplier and user?
9.
External influences coded BA are classified as?
10.
In a location containing a bath or shower supplementary bonding may be omitted, amongst other conditions, where?
11.
With regard to determining the frequency of periodic inspection and testing of an installation, which of the following does not need to be considered?
12.
A 230V circuit is protected by a 20A Type B circuit-breaker to BS EN 60898. The minimum value of fault current to ensure compliance with maximum disconnection times is?
13.
When did the Part P of the building regulations come in to effect?
14.
Which Classification does this symbol identify?
15.
A transportable leisure accommodation vehicle which includes means for mobility but does not meet the requirements for construction and use of road vehicles is a?
16.
A neutral can also be known as a?
17.
To prevent injury from falling objects, it is important to use?
18.
Electrical equipment with reinforced insulation provides?
19.
Which of the following systems shall not be used to supply equipment used in repair and alteration work on construction sites?
20.
An accident occurs, the cause of which is found to be a piece of faulty equipment. The action to be taken would be?
21.
For an agricultural location, in order to provide automatic disconnection of supply in circuits other than socket-outlet circuits, a disconnection device shall be installed having a maximum rated residual operating current of?
23.
When considering the fundamental principles, which of the following should a designer have knowledge of relative to the Nature of demand?
24.
A cable concealed in a wall outside the prescribed zones at a depth of less than 50 mm must?
25.
When making an assessment of the frequency and quality of maintenance, a factor to be considered is that:
26.
A safety harness must be worn when working?
27.
Which of the following acts or regulations are the Building regulations made under?
28.
The MAIN reason that good housekeeping is important in the workplace is to ?
29.
An approximation of the prospective fault current between line conductors, of a 3 phase supply can be determined by?
30.
Which part of the building regulations cover the Electrical Safety of a building?
By Neil